AASTRA DT690 for BusinessPhone User Guide EN - Manual (Page 115)

C ORDLESS P HONE FOR B USINESS P HONE
115 1424-EN/LZT 103 092 Uen D 2010-02-12
Using the desk PDM charger for software download and synchronization
of parameters is most often done by system administrators, and requires
that the charger is connected either to the LAN and CPDM or to a PC
with the WinPDM software application installed. For a short description
of CPDM and WinPDM, see WinPDM and CPDM on page 119.
The desk PDM charger is connected to a PC through the USB or one of
the network connectors, see figure 20 on page 115. When you connect
the charger with a PC through one of the network connectors, the
charger acts as a switch, making it possible to connect the other
connector to the LAN.
Figure 20:Network and USB Connectors
Note: Network and USB connectors are used to connect the desk PDM
chargers to a PC running the WinPDM or to the LAN (not for
charging).
20.3.3 Rack PDM Charger
The rack PDM charger is used for charging several phones, as well as
for software download, and synchronization of parameters. The built in
power supply can charge up to six cordless phones at once.
20.3.4 Battery Pack Rack Charger
The battery pack rack charger is used for charging up to six spare
batteries.