Garmin G950 Tecnam 2006T - Manual (Page 315)

190-01146-00 Rev. A Garmin G950 Pilot’s Guide for the Tecnam P2006T
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
303
APPENDIX A
Message Comments
ABORT APR – Loss of GPS navigation.
Abort approach.
Abort approach due to loss of GPS navigation.
APR DWNGRADE – Approach
downgraded.
Vertical guidance generated by WAAS is unavailable, use LNAV only minimums.
TRUE APR – True north approach.
Change HDG refereence to TRUE. Displayed after passing the first waypoint of a true north approach when the nav angle is
set to ‘AUTO’.
GPS1 SERVICE – GPS1 needs service.
Return unit for repair.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may still
be available. The G950 system should be serviced.
GPS2 SERVICE – GPS2 needs service.
Return unit for repair.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still
be available. The G950 system should be serviced.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or “pressed”)
state. Press the transfer switch again to cycle its operation. If the problem persists,
the G950 system should be serviced.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The G950
system should be serviced.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs service.
Return unit for repair.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The G950 system should be serviced when possible.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
GTX 33 MESSAGE ADVISORIES
Message Comments
XPDR1 CONFIG – XPDR1 config error.
Config service req’d. The transponder configuration settings do not match those of backup configuration
memory. The G950 system should be serviced.
MANIFEST – GTX1 software
mismatch, communication halted. The transponder has incorrect software installed. The G950 system should be
serviced.
XPDR1 SRVC – XPDR1 needs service.
Return unit for repair.
The #1 transponder should be serviced when possible.
XPDR1 FAIL – XPDR1 is inoperative. There is no communication with the #1 transponder.