System status, Hazard avoidance – Garmin G950 Tecnam 2006T User Manual
Page 292
![background image](/manuals/250604/292/background.png)
Garmin G950 Pilot’s Guide for the Tecnam P2006T
190-01146-00 Rev. A
280
HAZARD AVOIDANCE
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
Muting the “TIS Not Available” voice alert:
1)
Select the Traffic Map Page.
2)
Press the TNA MUTE Softkey. The status is displayed in the upper left corner of the Traffic Map Page.
Or
:
a)
Press the MENU Key.
b)
Select ‘‘’Not Available” Mute On’ (shown if TNA muting is currently off) and press the ENT Key.
SYSTEM STATUS
The G950 performs an automatic test of TIS during power-up. If TIS passes the test, TIS enters Standby Mode
(on the ground) or Operating Mode (in the air). If TIS fails the power up test, an annunciation is shown in the
center of the Traffic Map Page.
Traffic Map Page
Annunciation
Description
NO DATA
Data is not being received from the transponder*
DATA FAILED
Data is being received from the transponder, but
a failure is detected in the data stream*
FAILED
The transponder has failed*
UNAVAILABLE
TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 6-3 TIS Failure Annunciations
Figure 6-14 TIS Power-up Test Failure
Data Not
Received from
Transponder
System Test has
Failed