Acura 2012 TL - Manual (Page 98)

You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park (automatic) or
with the parking brake set (manual).
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFT TO PARK TO CHANGE
SETTINGS’’ (automatic) or ‘‘MUST
STOP AND SET PARK BRAKE
TO CHANGE SETTINGS’’
(manual) message and you cannot
change the settings.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure the driver’s door is
unlocked with a corresponding
remote transmitter/
keyless access remote.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, move the shift lever out of
Park (automatic) or release the
parking brake (manual), the display
will change to the normal screen.
Multi-Information Display
Customized Settings
94
11/01/14 18:10:38 31TK4630_099
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
Models equipped with the keyless access
system have an engine start/stop button instead of
an ignition switch. VEHICLE OFF (LOCK) Mode
is the equivalent of LOCK (0), ACCESSORY Mode
is the equivalent of ACCESSORY (I), and ON
Mode is the equivalent of ON (II). For more
information, see pages :
184 and 187.
2012 TL