Acura 2012 TL - Manual (Page 179)

The remote may not work if:
It is too close to the vehicle.
It is above or below the vehicle,
even when it is within its operating
range.
The handle of each front door has a
sensor. That sensor works with the
remote so you can automatically
unlock the door(s).
By default, only the driver’s door
unlocks when you grab its handle.
Each front door has a LOCK/
UNLOCK feature.
To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page
.
To unlock the remaining doors and
the trunk, press the UNLOCK
button on the remote or the rear of
the master door lock switch on the
driver’s door.
To change the ‘‘DOOR UNLOCK
MODE’’ setting, see page
.
All the doors unlock when you grab
the handle of the front passenger’s
door.
When you unlock the door(s), some
exterior lights blink twice and the
system beeps twice.
To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see
.
118
116
CONTINUED
Keyless Access System
Unlocking the Door(s)
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
175
11/01/14 18:24:22 31TK4630_180
page 117
2012 TL