Acura 2012 TL - Manual (Page 402)

Turn the selector knob to select
‘‘CALIBRATION.’’ Press the selector knob (ENTER)
to enter your selection. The
display shows you ‘‘PUSH CAL
START.’’
While setting the compass, press
the RETURN button to go back to
the previous display. Pressing the
SETUP button will cancel the
compass setting mode.
When the calibration is successfully
completed, the CAL indicator goes
off and the compass display will stop
blinking and show an actual heading.
The audio system is not related to
the compass system. Even if the
compass system is calibrating, the
display returns to the normal display
which you last selected.
Press the selector knob (ENTER).
The compass display is blinking
and the CAL indicator is shown.
Drive the vehicle slowly in two
complete circles.
3. 4.
5.
6.
Compass
398
11/01/14 19:02:51 31TK4630_403
Fe
a
tu
re
s
2012 TL