Acura 2012 TL - Manual (Page 79)

If the indicator comes on at any
other time, there is a problem with
BSI. You will also see a ‘‘CHECK
BLIND SPOT SYSTEM’’ message
on the multi-information display. If
this happens, take your vehicle to a
dealer, and have it checked. For
more information, see page
.
When this indicator is on,
BSI is not working.
This indicator normally comes on for
a few seconds when you select the
ON mode by operating the engine
start/stop button (see page
).
This indicator comes on as a
reminder that you have
turned off the blind spot
information system (BSI).
When you turn the system on, the
indicator will turn off.
The BSI indicator also comes on if
the rear bumper becomes dirty while
driving. You will see a ‘‘BLIND
SPOT NOT AVAILABLE’’ message
on the multi-information display.
When you clean the rear bumper,
the indicator should go off after you
begin driving again.
519 185
On models with blind spot information
system (BSI)
Blind Spot Inf ormation
System (BSI) Indicator
Instrument Panel Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
75
11/01/14 18:07:08 31TK4630_080
2012 TL