Acura 2012 TL - Manual (Page 571)

Slide the new wiper blade into the
holder until the tabs lock.
Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
Lower the wiper arm down against
the windshield, the passenger’s
side first, then the driver’s side.
Remove the blade from its holder
by grabbing the tabbed end of the
blade. Pull up firmly until the tabs
come out of the holder.
Examine the new wiper blades.
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the
Disconnect the blade assembly
from the wiper arm by pushing in
the lock tab. Hold the lock tab in
while you push the blade assembly
toward the base of the arm.
When replacing a wiper blade,
make sure not to drop the wiper
blade or wiper arm down on the
windshield.
3. 5.
4.
6.
7.
2.
Wiper Blades
Ma
int
e
na
nce
567
BLADE
BLADE
LOCK TAB
REINFORCEMENT STRIP
11/01/14 19:33:24 31TK4630_572
new blade.
If they have no plastic or metal
2012 TL