Acura 2012 TL - Manual (Page 72)

This indicator comes on as a
reminder that you have turned off
the vehicle stability assist (VSA)
system. This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page
.
This indicator has two functions:
It flashes when VSA is active (see
page
).
If it comes on and stays on at any
other time, there is a problem with
the VSA or Hill Start Assist (on
SH-AWD models only) system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ or ‘‘CHECK HILL
START ASSIST SYSTEM’’
message on the multi-information
display. Take your vehicle to a
dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have
VSA traction and stability
enhancement. For more
information, see page .
If the VSA indicator illuminates,
hill start assist will not be working.
Without hill start assist, the
vehicle will roll downhill
immediately when you release the
brake on an incline.
1.
2.
510
510
510
Vehicle Stability Assist
(VSA) System Indicator
VSA OFF Indicator
Instrument Panel Indicators
68
11/01/14 18:05:48 31TK4630_073
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
Models equipped with the keyless
access system have an engine start/stop
button instead of an ignition switch. ON
Mode is the equivalent of ON (II), and
START Mode is the equivalent of
START (III). For more information, see
pages
and
:
187 184 .
2012 TL