HONDA 2010 Ridgeline - Manual (Page 98)

OFF
INT: Intermittent
INT TIME ring
LO: Low speed
HI: High speed
MIST
Windshield washers
Turn signal
High beams
Flash high beams
The multi-control lever has many
functions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam flashing.
To select a position, turn the rotary
switch, push the button on the end of
the lever, or push the lever up, down,
forward, or backward.
The wipers are not activated.
The wipers run at low speed.
The wipers run at high speed.
The wipers run at high speed
until you release the lever.
The length of the wiper
interval is varied automatically
according to the vehicle’s speed.
Vary the delay by turning the
INT TIME ring. If you turn it to
the shortest delay, the wipers
change to low speed when the
vehicle speed exceeds 12 mph
(20 km/h).
Push the
button on the end of the
multi-control lever. The
washers spray until you
release the button. The
wipers run at low speed, then
complete one more sweep
after you release the button.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
OFF:
LO
HI
MIST:
INT:
Windshield Washer:
Multi-Control Lever
94
09/07/18 14:13:44 31SJC640_099
2010 Ridgeline