Instrument panel indicators – HONDA 2010 Ridgeline User Manual

Page 70

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position, and when the ignition
switch is turned to the START (III)
position. If it comes on at any other
time, there is a problem with the
ABS. If this happens, have your
vehicle checked at a dealer. With the
indicator on, your vehicle still has
normal braking ability but no anti-
lock brakes. For more information,
see page

This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It will
go off if you have inserted a properly
coded ignition key. If it is not a
properly coded key, the indicator will
blink and the engine will not start
(see page

This indicator also blinks several
times when you turn the ignition
switch from the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.

You will also see a ‘‘CHECK ABS
SYSTEM’’ message on the multi-
information display (see page

The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages

and

Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.

When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.

On models with navigation system

Anti-lock Brake System
(ABS) Indicator

Immobilizer System
Indicator

Turn Signal and
Hazard Warning
Indicators

Instrument Panel Indicators