HONDA 2010 Ridgeline - Manual (Page 173)

Press the TUNE bar to
change channel selections. Press
for higher numbered channels
and for lower numbered
channels. In the category mode, you
can only select channels within that
category.
Press either side of the CATEGORY
bar (
or ) to select another
category.
The scan function gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button or
touch the SCAN icon on the screen.
The system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to listen
to, press the button or touch the icon
again.
You can store up to 12
preset channels using each side of
the preset bar or preset icons on the
screen. Each side of the bar stores
one channel from the XM1 band and
one channel from the XM2 band.
Pick a preset number (icon) you
want for that channel. Press and
hold the bar (icon) until you hear a
beep.
Repeat steps 2 and 3 to store the
first six channels.
Once a channel is stored, press and
release the proper side of the preset
bar (icon) to tune to it.
To store a channel:
Press the XM button. Either XM1
or XM2 will show in the display.
Use the tune, seek, or scan
function to tune to a desired
channel.
Press the XM button again or
touch the other XM icon (XM1 or
XM2) on the audio display. Store
the next six channels using steps 2
and 3.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.
1.
2.
3.
4.
5.
TUNE
SEEK/SKIP (CATEGORY)
SCAN
Preset
Playing the XM Radio
Fe
a
tu
re
s
169
09/07/18 14:27:41 31SJC640_174
2010 Ridgeline