Vents, heating, and a/c – HONDA 2010 Ridgeline User Manual
Page 155
Set the fan and temperature
controls to maximum level.
Select
. The system
automatically switches to fresh air
mode and turns on the A/C.
The A/C ON indicator will not be
displayed if it was off to start with.
Select
.
Turning the fan speed control dial all
the way to the left shuts the system
off.
Keep the system off for short
periods only.
To keep stale air and mustiness
from collecting, you should have
the fan running at all times.
You can adjust the direction of the
air coming from the rear vents in the
back of the center console by
moving the tab in the center of each
vent up-and-down and side-to-side.
You can also adjust the amount of
airflow by turning the dial between
the vents.
To clear the windows faster, you can
close the dashboard corner vents by
rotating the wheel next to
(passenger’s side) or below it
(driver’s side). This will send more
warm air to the windshield defroster
vents. Once the windshield is clear,
select fresh air mode to avoid
fogging the windows.
For your safety, make sure you have
a clear view through all the windows
before driving.
1.
2.
3.
To Remove Exterior Frost or Ice
From the Windows
To Turn Everything Of f
Rear Ventilation
Vents, Heating, and A/C
Fe
a
tu
re
s
151
DIAL
TABS
09/07/18 14:24:19 31SJC640_156
2010 Ridgeline