HONDA 2010 Ridgeline - Manual (Page 159)

CONTINUED
This button directs the main airflow
to the windshield for faster
defrosting. It also overrides any
mode selection you may have made.
When you select , the system
automatically switches to fresh air
mode and turns on the A/C. For
faster defrosting, manually set the
fan speed to high. You can also
increase airflow to the windshield by
closing the corner vents on the
dashboard. To close the vents, rotate
the wheel under each corner vent.
When you turn off by
pressing the button again, the
system returns to its former settings.
Use the mode control button to
select the vents the air flows from.
Some air will flow from the
dashboard vents in all modes.
Air flows from the center,
corner, and rear vents in the
dashboard.
Airflow is divided between
the vents in the dashboard, rear and
the floor vents.
Air flows from the floor
vents.
Airflow is divided between
the floor and corner vents and the
defroster vents at the base of the
windshield.
When the indicator in the button is
on, air from the vehicle’s interior is
sent through the system again.
When the indicator is off, air is
brought in from the outside of the
vehicle (fresh air mode).
The outside air intakes for the
climate control system are at the
base of the windshield. Keep this
area clear of leaves and other debris.
The system should be left in fresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C off,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
Climate Control System
Windshield Def roster Button Mode Control Recirculation Button
Fe
a
tu
re
s
155
09/07/18 14:25:14 31SJC640_160
2010 Ridgeline