HONDA 2010 Ridgeline - Manual (Page 341)

Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
1.
2.
3.
4.
5.
6.
Lights
Ma
int
e
na
nce
337
WEATHER SEAL
CONNECTOR HOLD-DOWN WIRE
BULB
09/07/18 14:58:16 31SJC640_342
2010 Ridgeline