HONDA 2010 Ridgeline - Manual (Page 345)

Remove the three mounting
screws from the light assembly.
Remove the lens from the light
assembly.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Place a cloth on the edge of the
lens segment to prevent scratches.
Remove each lens segment by
carefully prying on its edge with a
small flat-tip screwdriver.
Remove the screw under each lens.
Pull the high-mount brake light
assembly out of the vehicle.
Install the new bulb into the
socket.
Push the socket into the light
assembly, and turn it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts securely.
1.
2.
3.
4.
5.
6.
6.
7.
8.
9.
CONTINUED
Replacing a High-mount Brake
Light Bulb
Lights
Ma
int
e
na
nce
341
LENS SEGMENT
SCREW
SCREW
BULB
09/07/18 14:59:06 31SJC640_346
2010 Ridgeline