HONDA 2010 Ridgeline - Manual (Page 279)

To shift from second to
first, pull the shift lever towards you,
then shift to the lower gear. This
position locks the transmission in
first gear. By upshifting and
downshifting through 1, 2, and D,
you can operate the transmission
much like a manual transmission
without a clutch pedal.
If you shift into first position when
the vehicle speed is above 28 mph
(45 km/h), the transmission shifts
into second gear first to avoid
sudden engine braking.
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
rpm below the red zone. This allows you to move the shift
lever out of Park if the normal
method of pushing on the brake
pedal and pulling the shift lever does
not work.
Set the parking brake.
Make sure the ignition switch is in
the LOCK (0) position.
Put a cloth on the notch of the
shift lock release slot cover to
prevent scratches. Using a small
flat-tip screwdriver or a metal
fingernail file, carefully pry on the
notch of the cover to remove it.
1.
2.
3.
CONTINUED
First (1) Engine Speed Limiter Shif t Lock Release
Automatic Transmission
D
riv
ing
275
09/07/18 14:46:58 31SJC640_280
2010 Ridgeline