HONDA 2010 Ridgeline - Manual (Page 186)

Your vehicle’s in-dash disc changer
holds up to six discs.
To load or play discs, the ignition
switch must be in the ACCESSORY
(I) or ON (II) position.
You operate the disc changer with
the same controls used for the radio.
To select the disc changer, press the
CD or CD/AUX button. You will see
‘‘CD’’ in the display. The disc and
track numbers, and the elapsed time
are shown in the display. You can
also select the displayed information
with the DISP button (see page
).
The system will continuously play a
disc until you change modes.
When ‘‘LOAD’’ appears again on
the display, insert the next CD into
the CD slot.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded.
Insert a CD into the CD slot.
Insert it only about halfway; the
drive will pull it in the rest of the
way. You will see ‘‘BUSY’’ in the
display. The CD load indicator
turns red and blinks as the CD is
loaded.
You cannot load and play 3-inch
(8-cm) discs in this system.
On the upper right side of the
display, the disc number for an
empty position will begin blinking,
and the green CD load indicator
will come on.
To load only one CD, press and
release the LOAD button.
Press and hold the LOAD button
until you hear a beep and see
‘‘LOAD’’ in the display, then
release the button.
3.
4.
5.
1.
2.
183
On RTS, RTL, and Canadian EX-L
models without navigation system
CD Changer (Models without navigation system)
Loading Discs
To Play a Disc
182
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
09/07/18 14:30:01 31SJC640_187
2010 Ridgeline