HONDA 2010 Ridgeline - Manual (Page 342)

Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Turn on the lights to make sure
the new bulb is working.
Put the inner fender cover in place.
Install and lock each holding clip
by pushing on the center.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
5.
6.
1.
2.
3.
4.
7.
Lights
Replacing a Front Turn Signal/
Hazard/Parking Light Bulb
338
HOLDING CLIPS
BULB
SOCKET
09/07/18 14:58:27 31SJC640_343
2010 Ridgeline