HONDA 2010 Ridgeline - Manual (Page 344)

Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the burned-out bulb by
pulling it straight out of the socket.
Drop open the tailgate.
Remove the two bolts, and remove
the rear light assembly from the
rear pillar.
Determine which of the three
bulbs is burned out: brake/
taillight, turn signal/hazard light,
or back-up light.
Install the new bulb into the hole
and turn it one-quarter turn
clockwise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the lights to test the new
bulb.
Reinstall the inner fender. Make
sure it is installed under the edge
of the front bumper.
Reinstall the holding clip, and push
in its head, then install the bolts
and tighten them securely.
1.
2.
3.
4.
5.
5.
6.
7.
8.
9.
Replacing Rear Bulbs
Lights
340
BULB
SOCKET
09/07/18 14:58:52 31SJC640_345
2010 Ridgeline