About this guide, Introduction, How to use this guide – 3Com 100 TX User Manual
Page 9: General information about the hub, Chapter 1, Instructions for mounting the hub, Chapter 2, Instructions for connecting the hub to the network, Chapter 3, Information about interpreting leds
A
BOUT
T
HIS
G
UIDE
Introduction
This guide describes how to mount the 3Com
®
LinkBuilder
®
FMS
™
100-TX Hub
in a rack, install the hub on the network, and interpret the hub’s front panel
LEDs. It also describes, in general terms, the functioning of the hub in a Fast
Ethernet network environment.
How to Use This
Guide
The following table shows where to find specific information in this guide.
If you are looking for:
Turn to:
General information about the hub
Chapter 1
Instructions for mounting the hub
Chapter 2
Instructions for connecting the hub to the network
Chapter 3
Information about interpreting LEDs
Chapter 3
Information about the hub’s transceiver interface modules
Chapter 3
Information about cabling requirements
Chapter 4
Information on hub specifications
Appendix A
Information about 3Com’s technical support services
Appendix B