Xerox 701P21091 - Manual (Page 339)

Specifying print format parameters
Using LCDS Print Description Language 4-99
Example 2 The following is an example of multiple BEGINs. Two logical
pages are defined on one physical page.
Example 3 This is an example of a PDE that may be compiled separately
from a JDL. The compilation process creates a .PDE object file,
which may be referenced from within a JDL or by a DJDE. The
name of the object file for this PDE is PDE99.PDE (the same as
its identifier in the source command shown below).
ROUTE command
The ROUTE command allows you to print identifying information
(text and an optional form) on a page preceding a report. You
may code this command within a JDL or in a disk file of ROUTE
commands.
ROUTE command parameters
The following table summarizes the ROUTE command
parameters.
The following sections describe the syntax of the ROUTE
command parameters and explain the parameter options.
2UP: PDE BEGIN=(.5 IN,.5 IN),
BEGIN=(6.5IN,.5 IN),
PMODE=PORTRAIT,
FONTS=P1012B;
PDE99: PDE PMODE=PORTRAIT,
BEGIN=(.10,0),
FONTS=(P07ITA,P08OAA);
END;
Table 4-87. Summary of ROUTE command parameters
Parameter Specifies Online Offline DJDE
ROUTE RFORM Specifies a form that will be printed with RTEXT
pages. Y Y Y
ROUTE RTEXT Specifies the text that will be printed preceding a
report copy. Y Y Y