Xerox 701P21091 - Manual (Page 282)

Specifying print format parameters
4-42 Using LCDS Print Description Language
OUTPUT command
The OUTPUT command controls the organization and format of
a report, including the number of copies of a report, the forms to
be printed with the variable data, report offsetting, and the use of
simplex or duplex mode. For further information on graphics
features, refer to the “Using PDL commands for graphics”
chapter.
OUTPUT command parameters
The following table summarizes the OUTPUT command
parameters.
Table 4-42. Summary of OUTPUT command parameters
Parameter Specifies Online Offline DJDE
OUTPUT BFORM Prints a specified form only on the back sides
of duplex pages. Y Y Y
OUTPUT BINDING Specifies page rotation for printing for short
edge or long edge binding. Y N N
OUTPUT COLLATE Specifies whether report pages will be
collated or uncollated. Y Y Y
OUTPUT COPIES Specifies the number of report copies that will
be printed. Y Y Y
OUTPUT COVER Feeds cover pages for a report from the tray
that contains the AUX stock. Y Y N
OUTPUT CYCLEFORMS Associates forms with report pages in a
repeating sequence. Y Y N
OUTPUT DENSITY Enables or disables image generator local
density functionality. (Listed for compatibility
purposes; not supported on DP EPS.) Y Y N
OUTPUT DESTINATION Specifies the destination for printed output. Y Y Y
OUTPUT DUPLEX Prints the job on both sides of the paper. Y Y Y
OUTPUT FACEUP Delivers and stacks the printed sheets face up
in the stacker. Y Y N
OUTPUT FEED Specifies the tray from which paper will feed
for the job. Y Y Y
OUTPUT FORMAT Specifies a page descriptor entry (PDE) for
the job. Y Y Y
OUTPUT FORMS Associates forms with report copies Y Y Y