Xerox 701P21091 - Manual (Page 159)

Specifying input parameters
Using LCDS Print Description Language 2-51
TCODE DEFAULT
Specifies an initial set of character type assignments for use with
masked comparisons. You may specify default assignments for
any standard character set by coding the appropriate keyword.
Syntax ac: TCODE DEFAULT = {tcode Type | value}
Options
Default No default
TCODE DEFAULT
parameter: points
to note
If you specify a tcode Type, this sets the following conditions:
• All numeric characters (0 through 9) are type 1 characters.
• All alphabetic characters (A through Z, a through z) are type
2 characters.
• All other characters are untyped.
TCODE TASSIGN
Associates one or more specified characters with one or more
specified type codes. May also be used to disassociate one or
more characters from all type code assignments. Can be
specified more than once in a TCODE command.
Syntax ac: TCODE TASSIGN = {(typespec, ’inputspec’) | (typespec,
(’inputspec
1
’ [’inputspec
2
’] [,...]))}
Table 2-53. TCODE DEFAULT parameter options and definitions
Option Definition
tcode Type Available tcode type keyword parameters are:
•
ASCII
• BCD
• EBCDIC
• PEBCDIC
• IBMBCD
value An integer from 0 to 7.
•
If you specify 0, all the characters are untyped.
• If you specify 1, all the characters are type 1. If you specify 7, all the
characters are type 7, and so forth.