Xerox 701P21091 - Manual (Page 311)

Specifying print format parameters
Using LCDS Print Description Language 4-71
However, if the OSTK command is specified, the system
allows a tolerance of n inches (where n is the width of the
tab specified in the OSTK command) when validity checks
are being performed on BEGIN values and graphic
positioning. In addition, the FEED=tab stock DJDE must
precede any printable text data that is placed on the tab.
– When running tab stock jobs, dedicate one tray for tab
stock.
– Avoid using tab stock with two-sided printing. When you
are feeding stock that contains tabs, turn off duplex
printing.
– When feeding from tab stock, be sure to convert the
DJDEs back to the following specifications after printing
the tabs, by using the following parameters:
• Specifying a tab as a form: To define a form that is to be
used as a tab in a form callout, it is recommended that you
code your applications with the following specifications:
– The JSL must specify PAPERSIZE=USLETTER (or
8.5,11 or A4).
– Your form must specify that the paper size is 9 by 11
inches or 8.5 by 11 inches, or A4 with 1/2 inch / 13 mm
tab.
– One tray must be dedicated for tabs. The JSL must
specify which stock name/reference contains the tab
stock.
– JDE and JDL DJDEs must be coded to define the
following for the tab stock:
PAPERSIZE = (9, 11) or 8.5 by 11 or A4 with 1/2 inch (13
mm) tab
FEED=tab stock
DUPLEX=YES or DUPLEX=NO
FORM=form name
– Corresponding JDE and JDL DJDEs must be coded to
switch back to printing regular paper stock. Note that the
ordered stock statement specified in the original JDE and
JDL DJDEs and the regular stock JDE and JDL DJDEs
must be exactly alike.
OUTPUT FEED=regular stock, DUPLEX=NO
(or DUPLEX=YES)