Xerox 701P21091 - Manual (Page 174)

Specifying input parameters
2-66 Using LCDS Print Description Language
Options
Default 80
VOLUME OPTIMIZE
Enhances the performance of the data stream.
NOTE: This parameter is supported only partially by the DP
EPS. The parameter options table below reflects only the options
that are supported.
Syntax VOLUME OPTIMIZE = {NCCHECK | NONE}
Options
VOLUME
OPTIMIZE
parameter: Point
to note
The NCCHECK option is supported for DP EPS only for Fuji
Xerox markets. It is processed in other markets as if NONE were
specified.
Table 2-71. VOLUME MINLAB parameter options and definitions
Option Definition
value Specifies in bytes the maximum length of the smallest physical block. The value
can range from 1 to 4095 bytes. The specified value must be less than the
MAXLAB value and must not exceed the BLOCK LENGTH.
Table 2-72. VOLUME OPTIMIZE parameter options and definitions
Option Definition
NCCHECK NCCHECK
Disables channel 9 and channel 12 detection. When this option is selected. the
host is not notified by the printing system each time channel 9 or 12 is
recognized. Any skips to channel 9 or 12 are allowed as for any other channel.
NOTE: This option is supported on the DP EPS only for Fuji Xerox markets. All
other DP systems process it as NONE.
NONE No optimization actions are taken.