ZyXEL Communications Broadband Security Gateway P-312 - Manual (Page 70)

P312 Broadband Security Gateway
IP Static Route Setup 5-1
Chapter 5
IP Static Route Setup
This chapter shows you how to configure static routes with your Prestige.
Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN.
Each remote node specifies only the network to which the gateway is directly connected, and the Prestige
has no knowledge of the networks beyond. For instance, the Prestige knows about network N2 in the
following diagram through remote node Router 1. However, the Prestige is unable to route a packet to
network N3 because it doesn’t know that there is a route through the same remote node Router 1 (via
gateway Router 2). The static routes are for you to tell the Prestige about the networks beyond the remote
nodes.
Figure 5-1 Example of Static Routing Topology