beautypg.com

Using the ftp command from the dos prompt, 1 using the ftp command from the dos prompt – ZyXEL Communications Broadband Security Gateway P-312 User Manual

Page 135

background image

P312 Broadband Security Gateway

10-8

Transferring Files

Figure 10-7

Telnet into Menu 24.7.2 - System Maintenance

To transfer the firmware and the configuration file, follow these examples:

10.6.1 Using the FTP command from the DOS Prompt

Step 1.

Launch the FTP client on your workstation.

Step 2.

Type

open

and the IP address of your Prestige.

Step 3.

You may press the [ENTER] when prompted for a username.

Step 4.

Type

root

and your SMT password as requested. The default is 1234.

Step 5.

Type

bin

to set transfer mode to binary.

Step 6.

Use “put” to transfer files from the workstation to the Prestige, e.g.,

put p312.bin ras

transfers the firmware on your computer (p312.bin) to the Prestige and renames it “ras”.
Similarly

put p312.rom rom-0

transfers the configuration file on your computer

(p312.rom) to the Prestige and renames it “rom-0”. See section 10.1 for more information on
filename conventions.

Step 7.

Type

quit

to exit the ftp prompt.

Menu 24.7.2 - System Maintenance - Upload Router Configuration File

To upload the router configuration file, follow the procedure below:

1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your router configuration file on your workstation,
which will be transferred to the "rom-0" file on the router.
4. The system reboots automatically after the upload router configuration
file process is complete.

For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading router firmware using TFTP (note
that you must remain on this menu to upload router firmware using TFTP),
please see your router manual.

Press ENTER to Exit: