ZyXEL Communications Broadband Security Gateway P-312 - Manual (Page 45)

P312 Broadband Security Gateway
Hardware Installation & Initial Setup 2-11
Figure 2-9 Menu 2 – WAN Setup
The MAC address field allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured,
the address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change
the setting in Menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
Table 2-6 WAN Setup Menu Fields
Field Description Examples
MAC Address
Assigned By Press the [SPACEBAR] to choose either of the two methods of
assigning a MAC Address. Choose Factory Default to select the
factory assigned default MAC Address. Choose IP Address attached
on LAN to use the MAC Address of that workstation whose IP you
give in the following field. Factory
Default
IP Address This field is applicable only if you choose IP Address attached on
LAN method. Enter the IP address of the workstation on the LAN
whose MAC you are cloning.
2.10 LAN Setup
This section describes how to configure the LAN using Menu 3 – LAN Setup (10/100 Mbps Ethernet).
From the Main Menu, enter 3 to open Menu 3.
Menu 2 - WAN Setup
MAC Address:
Assigned By=IP address attached on LAN
IP Address= 192.168.1.12
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle