ZyXEL Communications Prestige 128IMH - Manual (Page 81)

Prestige 128IMH ISDN Modem/ Router/Hub
Remote Node Configuration 4-9
Figure 4-3 Menu 11.2 - Remote Node PPP Options
The following table describes the Remote Node PPP Options Menu, and contains instructions on
how to configure the PPP options fields.
Table 4-3 Remote Node PPP Options Menu Fields
Field Description Option
Standard
PPP
Encapsulation Select the CISCO PPP only when this remote node
is a Cisco machine; otherwise, select the
Standard PPP.
CISCO
PPP
Compression Turn on/off Stac Compression. The default for this
field is Off.
On/Off
(Default =
Off)
Multiple Link Options:
BOD Calculation Select the direction of the traffic you wish to use in
determining when to add or subtract a link. The
default for this field is Transmit or Receive. Default =
Transmit or
Receive
Base Trans Rate Select the base data transfer rate for this remote
node in Kbps. There are two choices for this field-
64 where only one channel is used or 128 where
two channels are used as soon as a packet triggers
a call 64/128
Max Trans Rate Enter the maximum data transfer rate allowed for
this remote node. This parameter is in kilobits per
second. There are two choices for this field- same
as above. 64/128
Target Utility (kbps) Enter the two thresholds separated by a [-] for
subtracting and adding the second port. Default=10-
20