ZyXEL Communications Prestige 128IMH - Manual (Page 53)

Prestige 128IMH ISDN Modem/ Router/Hub
Hardware Installation and Setup 2-17
Figure 2-9 Menu 2 – ISDN Setup
Table 2-5 Menu 2 – ISDN Setup
Switch Type This field is fixed as DSS1.
B Channel Usage In general, this is Switch/Switch. If you are only using one B channel
(e.g., your Prestige is sharing the ISDN BRI line with another device
on the S/T bus), then select Switch/Unused. The default is
Switch/Switch.
ISDN Data &
Subaddress Enter the telephone number and the subaddress assigned to ISDN
data calls for the Prestige. The maximum number of digits is 19 for
the telephone number and 5 for the subaddress.
A/B Adapter 1 &
Subaddress Enter the telephone number and the subaddress assigned to A/B
Adapter 1 (PHONE1).
A/B Adapter 2 &
Subaddress Same as above for A/B Adapter 2 (PHONE2).
PABX Outside Line
Prefix Enter the number for outside line access if the Prestige is connected
to a PABX; otherwise, leave it blank. The maximum number of digits
is 4.
Outgoing Calling
Party Number You only need to fill in this field if your switch requires a specific
Outgoing Calling Party Number; otherwise, leave it blank.
Incoming Phone
Number Matching Determines how incoming calls are routed. The choices for this field
are Multiple Subscriber Number (MSN), Called Party Subaddress
and Don’t Care.
Analog Call Routing Select the destination for analog calls. The choices are A/B Adapter
1, A/B Adapter 2 and Ignore. This field is only applicable when
Incoming Phone Number Matching is Don’t Care.
Global Analog Call Select how to handle global analog calls. The choices are Accept
and Ignore. This field is not applicable when the Analog Call
Routing is Ignore.
Edit Advanced Setup Select Yes and press Enter to go to the advanced setup submenu.
2.8.8 Advanced Setup
Select Yes in the Advanced Setup field of Menu 2 – ISDN Setup above to display menu 2.1
below.