ZyXEL Communications Prestige 128IMH - Manual (Page 76)

Prestige 128IMH ISDN Modem/ Router/Hub
4-4 Remote Node Configuration
Incoming: Rem Node
Password Enter the password used when this remote node calls
your Prestige.
Incoming: Rem CLID This field is applicable only if Call Direction is either Both
or Incoming. Otherwise, an N/A appears in the field.
This is the Calling Line ID (the telephone number of the
calling party) of this remote node.
If you enable the CLID Authen field in Menu 13 – Default
Dial In, your Prestige will check the CLID in the incoming
call against the CLIDs in the database. If no match is
found and CLID Authen is Required, the call will be
dropped.
Incoming: Callback This field is applicable only if Call Direction is Both.
Otherwise, an N/A appears in the field.
This field determines whether or not your Prestige will call
back after receiving a call from this remote node.
If this option is enabled, your Prestige will disconnect the
initial call from this node and call it back at the Outgoing
Primary Phone Number (see below).
Enable
Disable
Outgoing: My Login
Name This is a required field [?] if Call Direction is either Both
or Outgoing. Enter the login name for your Prestige when
it calls this remote node.
Outgoing: My
Password This is a required field [?] if Call Direction is either Both
or Outgoing. Enter the password for your Prestige when
it calls this remote node.
This field sets the authentication protocol used for
outgoing calls.
Options for this field are:
l CHAP/PAP - Your Prestige will accept either CHAP
or PAP when requested by this remote node.
CHAP/PAP
l CHAP - accept CHAP only. CHAP
Outgoing: Authen
l PAP - accept PAP only. PAP
Outgoing: Pri(mary)
Sec(ondary
) Phone Your Prestige always calls this remote node using the
Primary Phone number first for a dial-up line.