ZyXEL Communications ZyXEL Vantage VSG-1000 - Manual (Page 26)

VSG-1000 Vantage Service Gateway
2-2 Hardware Installation and Connection
2.2 Hardware Connections
The following sections describe the hardware connections of the VSG.
2.2.1 Front Panel
The console, LAN and WAN ports and the LEDs are located on the front panel.
Figure 2-2 Front Panel
The LAN Port
Connect the LAN port on the VSG to an Ethernet switch or hub using a crossover Ethernet cable or directly to a
computer using a straight-through Ethernet cable.
The WAN Port
Connect the VSG to a network with broadband Internet service.
• Connect the WAN port to a router using a straight-through Ethernet cable.
• Connect the WAN port to a computer using a crossover Ethernet cable for system configuration.
The Console Port
Local management of the VSG is done through the console port. It requires a direct connection between the VSG
and a computer via a console cable. Refer to chapters on SMT configurations for more information.
2.2.2 Front Panel LEDs
The following table describes the LEDs on the front panel. All LEDs are green when turned on.
Table 2-1 Front Panel LEDs
LED STATUS DESCRIPTION
PWR On The VSG is receiving power.
Off The VSG is not receiving power.
LAN or WAN
LINK 10 On The port is operating at 10Mpbs.
Off No device is connected at 10Mpbs.
LINK 100 On The port is operating at 100Mbps.
Off No device is connected at 100 Mbps.
ACT On The port is receiving or sending data.
Blinking The port is receiving or sending data.
2.2.3 Rear Panel
The power socket, the fan and a ventilation hole are located on the rear panel as shown next.