Xerox Digital copier printers - Manual (Page 91)

6
6-13 Using the Fiery XJ Print Calibrator
Removing calibration
If desired, you can remove calibration from the Fiery SI. In general, it is not necessary
because any new calibration replaces the existing one.
T O REMOVE CALIBRATION USING THE C ONTROL P ANEL :
1. When the Fiery SI restarts, press the Menu key when prompted to enter Setup.
2. Press Run Setup.
3. Scroll down to choose Calibration.
4. Choose Remove Calibration.
5. When prompted, verify that you want to proceed with removing calibration.
The current calibration curves are removed and the printer is uncalibrated. After
calibration is removed, you can download a new calibration.
Using the Fiery XJ Print Calibrator
The Fiery XJ Print Calibrator allows you to perform extended calibration procedures
from your networked workstation. You can calibrate to targets provided with your
Fiery SI, or you can customize targets and calibration curves to suit the specific needs
of your printing environment.
N OTE : The utilities for Macintosh and Windows users are fundamentally the same;
differences are noted in this chapter. When you see a window or dialog box illustrated,
the Macintosh version comes first, followed by the Windows 95 version.
T O VIEW INFORMATION WITH THE F IERY XJ P RINT C ALIBRATOR :
1. Double-click the Fiery XJ Print Calibrator icon.
The Chooser window appears.
2. Select the Fiery SI in the Chooser window that appears and click Connect or OK.
If there is no Measurements file on the Fiery SI or no Target selected, you will be
notified during startup.