Calibrating with a densitometer – Xerox Digital copier printers User Manual
Page 89
6
6-11
Understanding calibration
10.
When prompted to Print Comparison Page, select Yes.
Verify that the colors on the page are correct.
11.
When Prompted to Overwrite Calibration, select Yes.
12.
Select Yes to confirm.
13.
When calibration is complete, choose Exit Calibration. This automatically restarts your
Fiery SI.
Calibrating with a densitometer
To calibrate with a densitometer, the Fiery SI must have a serial port to connect the
densitometer to. Contact your authorized service/support center for information about
Fiery SI hardware.
T
O
CALIBRATE
WITH
A
DENSITOMETER
:
1.
Connect the DTP32 densitometer to your Fiery SI
For instructions, see “Setting up the densitometer” on page 6-4.
2.
Restart the Fiery SI and press the Menu key when prompted to enter Setup.
3.
Press Run Setup.
4.
Scroll down to choose Calibration.
5.
Choose Calibrate.
The Calibration Method screen appears.
6.
Select Densitometer for the Calibration Method.
7.
When prompted to Select Target, use the up/down arrow keys to scroll through the list
of target names, then choose OK.
You can choose from the list of all targets on the Fiery SI. This includes several targets
included with the Fiery SI as well as any custom targets you have created from your
workstation with Fiery XJ Print Calibrator.