ZyXEL Communications 10 - Manual (Page 69)

ZyWALL 10~100 Series Internet Security Gateway
WAN and Dial Backup Setup 5-1
Chapter 5
WAN and Dial Backup Setup
This chapter describes how to configure the WAN using menu 2 and dial-backup using menus 2.1
and 11.1. Dial-backup applies to the ZyWALL 100 and 10W (see Table 1-1 Model Specific
Features).
5.1 Cloning The MAC Address
The MAC address field allows users to configure the WAN port's MAC address by using either the factory
default or cloning the MAC address from a computer on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
ZyXEL recommends that you clone the MAC address of a computer on your LAN
even if your ISP does not require MAC address authentication.
5.2 WAN Setup
From the main menu, enter 2 to open menu 2.
Figure 5-1 MAC Address Cloning in WAN Setup
The following table contains instructions on how to configure your WAN setup.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Phone Number=
Port Speed= 115200
AT Command String:
Init= at&fs0=0
Edit Advanced Setup= No