Zhone Technologies 600 - Manual (Page 78)

4-4 Server Cards
Model No. Running Head ACS-ATM Card User Screens and Settings ATM Card
Table 4-1. ACS-ATM Card Main Screen Actions (DS3)
Table 4-2. ACS-ATM Card Main Screen Options and Defaults (DS3)
STATE (DS3)
The State setting determines whether the port is active or inactive. Set State to stdby (standby)
for ports not being used or not yet configured. Set it to actv (active) for ports that are ready
for use for ATM traffic.
FORMAT (DS3)
The Format setting indicates the variety of DS3 C-bit application used by this port. The
choices are Cbit and M23. This parameter is defined in RFC 1407.
CELL FRM (DS3)
The Cell Framing setting indicates the way ATM cells are constructed from the DS3 bitstream.
The two options are plcp (cells are constructed from the PLCP mapping bits) and hcs (the cells
are constructed from the HEC in the cell header).
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Redraws the screen.
uNi Brings up the User Network Interface (UNI) Configuration Screen.
Vbr Brings up the Variable Bit Rate (VBR) Configuration Screen.
Cbr Brings up the Constant Bit Rate (CBR) Configuration Screen.
Perf Brings up the DS3 Port Performance Data Screen.
Main Returns to the System Main Screen. If changes are made to settings and not
saved, you will be prompted to save or lose changes.
Parameter User Options Default
STATE stdby actv stdby
FORMAT Cbit M23 Cbit
CELL FRM plcp hcs plcp
LB CFG off local line payld cell off
LB GEN off line paylod reset off
LB DET off on w/to off
TX CLKSRC line plcp line
TX-RX SCRAM yes no yes
TX-LBO off on off
IDLE-UASN uasn idle uasn