Zhone Technologies 600 - Manual (Page 65)

Server Cards 3-9
MCC Card ACS-MCC Card User Screens and Settings
Table 3-4. Port Screen Option Settings and Defaults
Notes:
1. For ports C1, C2, and C3, the options are hdlc (default) and fr. For ports 1 to 128, the
options are b7r (default) and b4r.
STATE
The State setting determines whether the port is active or inactive. Set the State setting to
stdby (standby) for ports you are not using or have not yet configured. Set it to actv (active)
for ports that are ready for use.
WAN
The WAN setting identifies the WAN link on which the system information is sent. This signal
will come from either the distant system unit or the DACSII

. The options are none and w1-1
to w4-2. Ports 65 to128 are limited to WAN links w2-1 through w4-2.
TS
The Time Slot setting identifies the specific time slot on the WAN link (from the previous
paragraph) used for this particular port. The options are n/a, 1-24 (for T1 links) and 1-31 (for
E1 links).
IP ADDR
The IP Address setting identifies the IP Address of the remote end. Any unique valid IP
address is acceptable.
Parameter User Options Notes Default
STATE stdby actv stdby
WAN none w1-1 through w4-2 none
TS n/a 1-24 1-31 n/a
IPADDR ip 0.0.0.0
NETMASK ip 0.0.0.0
FORMAT b7r b4r hdlc fr 1 see note 1
RIP off rx tx rx/tx off
SH off on off
WEIGHT 1-15 1