Baud rate (setting) 4-2, Data bits (setting) 4-2, Dtr/dsr data flow control (setting) 4-2 – Zebra Technologies 160S User Manual
Page 54: Error detection (setting) 4-2, Parity (setting) 4-2, Xon/xoff data flow control (setting) 4-2, Option switches, Configuration and calibration
Configuration and Calibration
Option Switches
These switches are located at the
rear of the printer above the Signal
Interface Cable Connection. See
Figure 4.2.
In the tables on the following page,
an “R” means the switch is OFF (po-
sitioned to the right), while an “L”
means the switch is ON (positioned
to the left). All switches are in the
OFF position when the printer is
shipped from the factory.
Zebra S-Series User’s Guide
4-1
Figure 4.1 Option Switches
Figure 4.2 Location of Option Switches
53
This manual is related to the following products: