105se 2-12, Cutter mode, Fanfold media – Zebra Technologies 160S User Manual
Page 34
Cutter Mode
Follow the instructions described in Roll Media with the exception of
step 6: first route the media through the Cutter Module (see Figures
and
) and then close the printhead assembly by moving the lever lo-
cated on the upper printhead assembly to the CLOSED position.
Fanfold Media
To load fanfold media, place the fanfold media in the bottom or to the
rear of the media compartment or Fanfold Supply Bin (105Se only) and
thread it through the printhead as shown in Figures
2.7
and
. Adjust
the media guide using the thumb screw to keep the media from drifting
left or right.
Fanfold media from outside the printer feeds through one of the two ac-
cess slots, one at the bottom of the printer and one at the rear.
Zebra S-Series User’s Guide
2-11
Figure 2.7 Fanfold Media Loading Diagrams (105Se)
33