Calibrate 3-6, Darken 3-6, Data 3-6 – Zebra Technologies 160S User Manual
Page 42: Paper/ribbon 3-6, Pause 3-6, Position 3-6, Power 3-6, Printhead 3-6, Mode key, Front panel lights
MODE Key
The MODE key puts the printer in Configuration Mode. In this mode,
you can adjust the Print Darkness, Media Tear-Off Position, and Label
Top Position, or perform a Calibration. See
Front Panel Lights
Refer to
for the location of the lights.
Note: If an operating condition which causes a light to be ON
constantly and one which causes the same light to flash occur
simultaneously, the light flashes.
Zebra S-Series User’s Guide
3-5
41
This manual is related to the following products: