ZyXEL Communications ZyXEL Dimension GS-2024 - Manual (Page 108)

Chapter 12 Broadcast Storm Control
GS-2024 User’s Guide
108
The following table describes the labels in this screen.
Table 28 Advanced Application > Broadcast Storm Control
LABEL DESCRIPTION
Active Select this check box to enable traffic storm control on the Switch. Clear this check
box to disable this feature.
Storm Control
Type
Select the type(s) of packets you want to control. You can select Broadcast only;
Broadcast and multicast; Broadcast and unknown unicast; or Broadcast,
multicast, and unknown unicast.
Packet Limit Select the maximum number of packets of the specified type(s) that the Switch
accepts each second.
Port This field displays a port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this to control the specified type(s) of packets on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.