Xerox 575 - Manual (Page 51)

Programming the Machine
WorkCentre Pro 555/575 2-33
5. The Master Department Code entry is completed. To setup
individual Department Codes, go to step 6. To exit this feature,
press
Stop.
6. Enter a number between 2 and 50 to assign to this Department,
then press
Enter.
7. Using the Numeric Keypad, enter the name to assign to this
Department (max 20 characters), then press
Enter. Refer to the
“Character Entries” Section.
8. Using the Numeric Keypad, enter the 5-digit Department Code to
assign to this Department, then press
Enter.
9. The Department Code entry is completed. To set additional
Department codes, repeat steps 6 through 8. To exit this feature,
press
Exit or Stop.
Note: The 5-digit Department Code is required to access and
operate the WorkCentre.
Dept. number (1-50)
[ ]
Name (40 max)
[ ]
Dept. code
[ ]