Xerox 575 - Manual (Page 128)

Transmitting Documents
5-24 WorkCentre Pro 555/575
Send After Scan Enable
Once the Send After Scan Mode Default Setting is set to “OFF”, this
feature allows you enable the Send After Scan mode for a single
transmission. Once that transmission is complete, the default status
is regained.
To set the Send After Scan feature:
1. Load the document face down in the Document Support.
2. Select the desired Resolution and Contrast.
3. Press:
4. Select the Send After Scan option.
To enable the Send After Scan Mode for this transmission, press
, then go to step 5.
To disable the Send After Scan Mode for this transmission, press
, then go to step 6.
Menu
1.On
Send after scan
2.Off
2.Send scanned pages
When memory full
1.Cancel sending