Xerox 575 - Manual (Page 121)

Transmitting Documents
WorkCentre Pro 555/575 5-17
One Time Fax Options
Before sending a document, you can set up various options that
effect only the current job. With the document in the Document
Support, set each option you want to apply to that job, then using one
of the dialing methods, send the fax. The following options can be set
for an individual transmission:
Option Description
Number of
Pages Prints the designated number of pages at the top of the
recording paper for Direct Send Transmissions only.
Listen to Dial Turns the speaker ON to monitor the line tones.
Send then
Poll Sends a document, then polls a document from the remote
machine during the same transmission.
ECM Disable When the ECM default mode is set to On, allows you to
disable ECM for the current transmission .
Secure Send
Transmission The WorkCentre compares the number you dialed with the
remote machine’s ID. If the numbers do not match, the
document is not sent.
Send After
Scan Once the Send After Scan Mode Default Setting is set to
Off, this feature allows you enable the Send After Scan
mode for a single transmission.