Xerox 4508 - Manual (Page 52)

T h e R e m o t e C o n t r o l P a n e l ( R C P )
5-14 ❖ D o c u P r i n t 4 5 0 8 U s e r G u i d e
Remote Control
Panel for DOS
Switch to the directory which contains the DOS RCP
(example: CD:\DOSUTIL).
• To start the Remote Control Panel for DOS, at the DOS
prompt, type “DOSRCP” and press enter.
• The Remote Control Panel for DOS is somewhat different
from that for Windows. If you change any item in the
Remote Control Panel for DOS, you must send it to printer
by selecting the “Send settings to printer” item from the
File menu.
• The following figure is an example of the Remote Control
Panel for DOS.
File
FILE: Save and open RCP file and communicate with printer
Settings source: D:\WBFONT\DOSRCP\SETTINGS.DCP
DocuPrint 4508 REMOTE CONTROL PANEL
(c) 1995
Corporation
Help About eXit
Over-
View
Printing
Paper Size Font Emulation Auto Cont Connection Activation
Paper Feed Point Size Resolution Toner Save Robust Poll Time
Orientation Pitch Time Out Power Save Baud Rate Location
Copies Symbol Set Paper Type Density Msg Time
Form JamRecover Hot Key
Typefaces Job Config Interface Status/test
Letter Courier PCL5e On LPT1 Error Mess
Auto Ignored 600 dpi Off On 1
Portrait 10.00 20 30 min 9600 1,1
1 Roman-8 Normal Medium 99: 0
60 Off X
Defaults
4508-c05.frm Page 14 Wednesday, May 22, 1996 7:09 AM