Xerox 4508 - Manual (Page 21)

I n s t a l l i n g S o f t w a r e
C h a p t e r 2 : S e t t i n g U p t h e P r i n t e r ❖ 2-11
Installing
Software
Windows Setup Follow the steps below to install the Remote Control Panel
(RCP), Status Monitor, printer driver, and Font Manager for
Windows.
DOS Setup Follow the steps below to install the Remote Control Panel
(RCP), Status Monitor, and printer driver software for DOS.
1 Insert the 3.5” diskette labeled “Xerox DocuPrint 4508
Software Installation Diskette” into the disk drive of your
computer.
2 In the Program Manager, click on File, then click on Run and
type:
a : \ s e t u p or b : \ s e t u p
Then click OK.
3 Follow the instructions on the screen.
4 Insert the 3.5” diskette labeled “Xerox Font Manager” into
the disk drive of your computer. Follow steps 2 and 3.
1 Insert the 3.5” diskette labeled “DOS and OS/2 Drivers” into
the disk drive of your computer.
2 Switch to the drive in which the diskette was inserted.
Example: Type
a : or b : then press the return key.
3 Type R E A D M E , then press the return key.
4 Follow the instructions on the screen.
4508-c02.frm Page 11 Thursday, June 6, 1996 12:04 PM