Xerox 4508 - Manual (Page 19)

I n s t a l l i n g C o m p o n e n t s
C h a p t e r 2 : S e t t i n g U p t h e P r i n t e r ❖ 2-9
Interface Cable Connect the interface cable to the PC and printer.
Power Cord This printer does not have a power switch. It is automatically
powered on when plugged into an AC power socket. This
printer is equipped with advanced energy conservation
technology which reduces power consumption when it is not
in active use. Plug the power cord into a 3-wire grounded
power socket. The printer will power on and the READY LED
will illuminate. If the READY LED does not illuminate, see
Chapter 6: Troubleshooting.
Note
An interface cable is not supplied with the printer.
If you do not have a cable, purchase the cable separately from
your supplier.
For best performance and guaranteed bi-directional
communication, use a good, shielded parallel cable with the
IEEE P-1284 compatible pin configuration.
Figure 2.4 Power cord
4508-c02.frm Page 9 Thursday, June 6, 1996 12:04 PM