ZyXEL Communications P-660HN-TxA - Manual (Page 93)

Chapter 7 LAN Setup
P-660HN-TxA User’s Guide
93
7.3 The DHCP Setup Screen
Use this screen to configure the DNS server information that the ZyXEL Device
sends to the DHCP client devices on the LAN. Click Network > DHCP Setup to
open this screen.
Figure 38 Network > LAN > DHCP Setup
The following table describes the labels in this screen.
Table 23 Network > LAN > DHCP Setup
LABEL DESCRIPTION
DHCP Setup
DHCP
If set to Server, your ZyXEL Device can assign IP addresses, an IP
default gateway and DNS servers to Windows 95, Windows NT and
other systems that support the DHCP client.
If set to None, the DHCP server will be disabled.
If set to Relay, the ZyXEL Device acts as a surrogate DHCP server
and relays DHCP requests and responses between the remote server
and the clients. Enter the IP address of the actual, remote DHCP
server in the Remote DHCP Server field in this case.
When DHCP is used, the following items need to be set:
IP Pool Starting
Address This field specifies the first of the contiguous addresses in the IP
address pool.
Pool Size This field specifies the size, or count of the IP address pool.
Remote DHCP
Server If Relay is selected in the DHCP field above then enter the IP
address of the actual remote DHCP server here.
DNS Server