VIEWSONIC PJ1165 - Manual (Page 28)

ViewSonic PJ1165 27
INPUT Menu
With the INPUT menu, the items shown in the table below can be
performed. Perform each operation in accordance with the
instructions in the table below.
(This table is continued to the following page.)
Item Description
COLOR SPACE Select a color space mode using the S/T buttons.:
AUTO RGB SMPTE240 REC709 REC601
Selecting the AUTO automatically selects the optimum mode.
memo
This item can be selected only at a RGB signal or a component
video signal other than a COMPONENT port input of 525i/625i/
SCART RGB.
memo
The AUTO operation may not work well at some signals. In such a
case, select the SMPTE240 or the REC709 for a HDTV signal.
COMPONENT Select a function of COMPONENT port using the S/T buttons.:
COMPONENT SCART RGB
When the SCART RGB is selected, the COMPONENT port function
as a port for a SCART RGB signal input. Please refer to the section
“Connecting Your Devices”.
VIDEO Select a signal type mode using the S/T buttons.:
AUTO NTSC PAL SECAM NTSC4.43 M-PAL N-PAL
Selecting the AUTO automatically selects the optimum mode.
memo
This item is performs only at a video signal from the VIDEO port
or the S-VIDEO port. For a component video signal, the signal type is
identified automatically independently of this function.
memo
The AUTO operation may not work well at some signals. If the
picture becomes unstable (ex. a irregular picture, a color lack), please
select the mode depending on the input signal.
3D-YCS Select the TURN ON or the TURN OFF using the S/T buttons.:
TURN ON TURN OFF
When the TURN ON is selected, the 3D-YCS mode works for a
completely still image, or images with few motions.
memo
This item performs only at a video signal of NTSC3.58.
memo
When this function performs, the setting of the item “VIDEO NR”
of this INPUT menu is not effective.
VIDEO NR Select a noise reduction level using the S/T buttons.:
HIGH MIDDLE LOW
The noise on screen is reduced according to the selected level.
memo
This item performs only at a video signal from the VIDEO port or
the S-VIDEO port. At a video signal of NTSC3.58, this function
performs only when the TURN OFF is selected to the item “3D-YSC”
of this INPUT menu.
memo
When this adjustment is excessive, certain degradation may
appear on the picture.